The Mitsubishi Delica D:5 is one of the trickier people-movers to fit a roof rack to. It has no rain gutters, no factory roof rails, and the sliding doors leave very little for a normal door-jamb clamp to hold on to. We get asked about it often, so we worked out a proper solution: a purpose-made hook that locks onto the metal bracket hidden under the Delica's roof moulding. Combined with our Heavy Duty roof rack and 1.5 m crossbars, it gives a solid, drill-free fit.

Mitsubishi Delica D:5 fitted with KiwiSafety Heavy Duty 1.5 m roof rack, rear view

Quick answer

  • Vehicle: Mitsubishi Delica D:5 (2007 onwards), bare roof without factory rails
  • Rack: KiwiSafety Heavy Duty roof rack
  • Crossbar length: 1.5 m
  • Fixing method: custom hook onto the bracket under the roof moulding strip
  • Drilling: none

Why the Delica D:5 needs a different hook

Most of our Heavy Duty installs clamp into the top of the door opening. On the Delica D:5 that does not work well, because the rear doors slide and the roof edge is shaped differently from a van with gutters.

What the Delica does have is a black plastic moulding strip running along each side of the roof. Lift that strip and you will find metal brackets sitting in the roof channel underneath. They are part of the vehicle body, and they make a strong, hidden anchor point.

Metal bracket under the roof moulding strip of a Mitsubishi Delica D:5

Our hook design

We designed and made a hook shaped specifically for this bracket. It reaches down into the roof channel beside the moulding and catches on the bracket, so when the foot is tightened the rack is pulled firmly down onto the roof. The slot in the hook gives adjustment, and the foot width on the Heavy Duty rack is adjustable too, so each foot can be set to sit correctly on the Delica's roof.

Custom roof rack hook gripping under the roof moulding on a Mitsubishi Delica D:5

How we install it

  1. Clean the roof where the four feet will sit, so the rubber pads seat on a clean surface.
  2. Locate the brackets. Gently lift the roof moulding strip to find the metal brackets in the channel on each side.
  3. Position the two crossbars. Set the front and rear 1.5 m bars square to the vehicle and the same distance in from each side.
  4. Engage the hooks. Slide each custom hook into the channel so it catches the bracket under the moulding.
  5. Tighten evenly. Tighten left and right sides a little at a time so the bar stays centred, then fully tighten all four feet.
  6. Check. Push and pull each bar firmly by hand. Nothing should move. Re-check the bolts after the first drive and before long trips.

Front view of Heavy Duty roof rack installed on a Mitsubishi Delica D:5 at the KiwiSafety workshop

Why 1.5 m crossbars?

The Delica D:5 has a wide, square roof. The 1.5 m bar spans it with a useful overhang on each side for ladders, timber, kayaks or a roof box, without sticking out past the mirrors.

Finished roof rack installation on a Mitsubishi Delica D:5

Frequently asked questions

Which roof rack fits a Mitsubishi Delica D:5?

The KiwiSafety Heavy Duty roof rack with 1.5 m crossbars, fitted with our custom Delica hook that grips the bracket under the roof moulding.

Do you need to drill the roof?

No. The hook uses the existing metal bracket under the roof moulding strip, so there is no drilling and the rack can be removed later.

Will the sliding doors still open normally?

Yes. The hooks attach at the roof channel, not in the door opening, so they stay clear of the sliding doors.

My Delica has factory roof rails. Is this the right rack?

This install is for the bare-roof Delica D:5. If yours has factory rails, send us a photo and we will tell you which rack suits.

How much weight can I carry?

Always stay within the roof load limit in your Delica's owner's handbook, and spread the load evenly across both bars.

Can you fit it for me?

Yes. We fit roof racks at our workshop at Unit 14/77 Porana Rd, Glenfield, Auckland. We also ship NZ-wide with the Delica hooks included, for owners who prefer to fit it themselves.

Order a Delica D:5 roof rack

Order the Heavy Duty roof rack, choose the 1.5 m bar, and tell us in the order notes that it is for a Mitsubishi Delica D:5 so we include the correct hooks. Not sure about your model or year? Call us or send a photo of your roof and we will confirm the fit.